Port-Based Vlan Setup; Configure A Port-Based Vlan - ZyXEL Communications GS1915 Series User Manual

Table 56 Advanced Application > VLAN > VLAN Configuration > Vendor ID Based VLAN Setup
LABEL
Delete
Cancel

9.10 Port-Based VLAN Setup

Port-based VLANs are VLANs where the packet forwarding decision is based on the destination MAC
address and its associated port.
Port-based VLANs require allowed outgoing ports to be defined for each port. Therefore, if you wish to
allow two subscriber ports to talk to each other, for example, between conference rooms in a hotel, you
must define the egress (an egress port is an outgoing port, that is, a port through which a data packet
leaves) for both ports.
Port-based VLANs are specific only to the Switch on which they were created.
Note: When you activate port-based VLAN, the Switch uses a default VLAN ID of 1. You
cannot change it.
Note: In screens (such as IP Setup and Filtering) that require a VID, you must enter 1 as the VID.
The port-based VLAN setup screen is shown next. The CPU management port forms a VLAN with all
Ethernet ports.

9.10.1 Configure a Port-Based VLAN

Select Port Based as the VLAN Type in the Basic Setting > Switch Setup screen and then click Advanced
Application > VLAN from the navigation panel to display the next screen.
Chapter 9 VLAN
DESCRIPTION
Click Delete to remove the selected entry from the summary table.
Click Cancel to clear the check boxes.
GS1915 Series User's Guide
130