Configuring Snmp Trap Group - ZyXEL Communications XGS2210-28 User Manual

Table 197 Management > Access Control > SNMP (continued)
LABEL
Trap Community
Trap Destination
Version
IP
Port
Username
Apply
Cancel

45.3.1 Configuring SNMP Trap Group

From the SNMP screen, click Trap Group to view the screen as shown. Use the Trap Group screen to
specify the types of SNMP traps that should be sent to each SNMP manager.
Figure 346 Management > Access Control > SNMP > Trap Group
The following table describes the labels in this screen.
Table 198 Management > Access Control > SNMP > Trap Group
LABEL
Trap Destination IP
Type
Chapter 45 Access Control
DESCRIPTION
Enter the Trap Community string, which is the password sent with each trap to the SNMP
manager.
The Trap Community string is only used by SNMP managers using SNMP version 2c or lower.
Use this section to configure where to send SNMP traps from the Switch.
Specify the version of the SNMP trap messages.
Enter the IP addresses of up to four managers to send your SNMP traps to.
Enter the port number upon which the manager listens for SNMP traps.
Enter the username to be sent to the SNMP manager along with the SNMP v3 trap.
This username must match an existing account on the Switch (configured in Management >
Access Control > Logins screen).
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
DESCRIPTION
Select one of your configured trap destination IP addresses. These are the IP addresses of the
SNMP managers. You must first configure a trap destination IP address in the SNMP Setting
screen.
Use the rest of the screen to select which traps the Switch sends to that SNMP manager.
Select the categories of SNMP traps that the Switch is to send to the SNMP manager.
XGS2210 Series User's Guide
438