Lldp-Med Configuration - ZyXEL Communications XS1930 Series User Manual

Table 126 Advanced Application > LLDP > LLDP Configuration > Org-specific TLV Setting
LABEL
MAC/PHY
Max Frame Size
Apply
Cancel

31.7 LLDP-MED Configuration

Click Advanced Application > LLDP > LLDP-MED Configuration to display the screen as shown next.
Figure 179 Advanced Application > LLDP > LLDP-MED Configuration
The following table describes the labels in this screen.
Table 127 Advanced Application > LLDP > LLDP-MED Configuration
LABEL
Port
*
Notification
Topology
Change
MED TLV Setting
Location
Network Policy
Chapter 31 Link Layer Discovery Protocol (LLDP)
DESCRIPTION
Select the check box(es) to enable or disable the sending of IEEE 802.3 MAC/PHY
Configuration/Status TLVs on the port(s). All check boxes in this column are enabled by
default.
Select the check box(es) to enable or disable the sending of IEEE 802.3 Max Frame Size TLVs
on the port(s).
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
DESCRIPTION
This displays the Switch's port number. Select * to configure all ports simultaneously.
Use this row to make the setting the same for all ports. Use this row first and then make
adjustments to each port if necessary.
Changes in this row are copied to all the ports as soon as you make them.
Select to enable LLDP-MED topology change traps on this port.
Select to enable transmitting LLDP-MED location TLV.
Select to enable transmitting LLDP-MED Network Policy TLV.
XS1930 Series User's Guide
252