Single Ip Settings - D-Link DGS-1510 Series Web Ui Reference Manual

DGS-1510 Series Gigabit Ethernet SmartPro Switch Web UI Reference Guide
3. This version will support switch upload and downloads for firmware, configuration files and log files,
as follows:
a. Firmware – The switch now supports MS firmware downloads from a TFTP server.
b. Configuration Files – This switch now supports downloading and uploading of configuration files
both to (for configuration restoration) and from (for configuration backup) MS's, using a TFTP
server.
c. Log – The Switch now supports uploading MS log files to a TFTP server.
4. The user may zoom in and zoom out when utilizing the topology window to get a better, more defined
view of the configurations.

Single IP Settings

This window is used to configure the SIM settings. The Switch is set as a Candidate (CaS) as the factory
default configuration and Single IP Management is disabled.
To view the following window, click Management > Virtual Stacking (SIM) > Single IP Settings, as
shown below:
The fields that can be configured for SIM State Configure are described below:
Parameter
SIM State
Click the Apply button to accept the changes made.
The fields that can be configured for SIM Role Configure are described below:
Parameter
Role State
Figure 4-48 Single IP Settings window
Description
Select this option to enable or disable the SIM state on the Switch.
Select Disabled to render all SIM functions on the Switch inoperable.
Description
Select to change the SIM role of the Switch. Options to choose from
are Candidate, and Commander.
Candidate - A Candidate Switch (CaS) is not the member of a SIM
group but is connected to a Commander Switch. This is the default
setting for the SIM role of the Switch.
Commander – Select to make the Switch a Commander Switch (CS).
The user may join other switches to this Switch, over Ethernet, to be
part of its SIM group. Choosing this option will also enable the Switch
to be configured for SIM.
70