Fan-Fold Guides; Media Roll Retainer - Intermec EasyCoder PX4i User Manual

Chapter 8 — Options

Fan-Fold Guides

Media Roll Retainer

80
Should you inadvertently cut through self-adhesive labels, you
will have to clean the cutting parts. Tilt the cutter unit down and
wipe it using a piece of tissue moistened with isopropyl alcohol.
The cutting edge will rotate when the power is switched on
and when the printer is re-booted. Always keep the cutter in
closed position during operation. Switch off the power or
disconnect the cutter before cleaning. Keep your fingers away
from cutting edges!
Note: The cutter must be enabled during Configuration in Setup
Mode. For more information, see
"Configuration" on page
and
The fan-fold guides provide more exact routing of the media
when the supply is placed outside the media compartment, such
as a stack of fan-folded tickets. The guides come as an operator-
installable kit with installation instructions. The guides can be
fitted in the upper or lower slot in the rear plate.
Instructions for loading the media are included in the section
"External Supply (Fan-Fold)" on page
The media roll retainer is intended for applications where the
media may become misaligned on the media supply hub. The
plastic wing-shaped retainer is simply slipped onto the media
supply hub outside the media roll by the operator. No tools are
required.
"Cutter (option)" on page 67
75.
45.
EasyCoder PX4i User's Guide (IPL Version)