Label Taken Sensor (Option); Returning To Factory Default Setup - Intermec EasyCoder PX4i User Manual

Chapter 6 — Setting Up the Printer

Returning to Factory Default Setup

68

Label Taken Sensor (option)

To make the printer work in self-strip mode, that is, waiting for a
label to be removed before the next label is printed, the self-strip
mode must be enabled. This can also be done by executing the
following commands:
<STX>R<ETX> enter print/configuration mode
<STX><SI>t0<ETX>Disable self-strip
<STX><SI>t1<ETX> Enable self-strip
If the label taken sensor does not work properly, the sensitivity
can be calibrated in the Setup Mode. Select "LTS Calibration"
and follow the instructions in the display. Make sure that no
direct sunlight or interior lighting interferes with the label taken
sensor.
There are three ways to return to the factory default setup of the
printer:
• Insert a special CompactFlash memory card and restart the
printer.
• Use the Memory Reset option in the Test/Service part of the
Setup Mode.
• Use the printer's built-in keyboard
To return to factory default setup using the keyboard
1 Lift the printhead.
2 Switch on the power to the printer and press the <i> key and
wait until the printer beeps.
3 Swiftly press the following keys:
4 The following message will be displayed:
EasyCoder PX4i User's Guide (IPL Version)