Intermec EasyCoder PX4i User Manual page 101

Chapter 9 — Troubleshooting
86
Note 1: This is only applicable for printers equipped with an
EasyLAN interface.
Note 2: A printer that is equipped with an EasyLAN interface,
but is not connected to a network, will have a blinking RTW. To
avoid this, the user can set "IP SELECTION" to "MANUAL"
and "IP ADDRESS" to "0.0.0.0". This will indicate that the user
does not regard the lack of network connection as an error.
Note 3: No trap can be sent when this error/event occurs.
Note 4: This error indicates that the printer has not received an
IP address. It is only applicable for printers with IP
SELECTION set to DHCP and/or BOOTP.
Note 5: At most, but not all, printer crashes, the console is reset.
This will make the RTW go off.
Note 6: If the printhead temperature raises above 100°C (212°F),
an error occurs and the printing will be paused until the
printhead has cooled off. Meanwhile, the printer is able to receive
commands and data until the buffer is filled. The printing is
automatically resumed when the printhead temperature has
reached 85°C (185°F).
EasyCoder PX4i User's Guide (IPL Version)