Intermec EasyCoder PX4i User Manual page 116

EasyCoder PX4i User's Guide (IPL Version)
5 Disconnect the hooked printhead bracket fingers from the
shaft and pull out the printhead as far as the cables allow.
6 Disconnect the cables from the print-head. Note the snap-
lock on the inner connector. Pull at the connectors—not at
the cables!
7 Connect the two cables to the replacement printhead.
8 Fit the hooks of the printhead bracket fingers onto the
headlift shaft. Make sure that the cables do not prevent the
bracket fingers from being properly seated on the headlift
shaft.
9 Close the printhead so the magnet engages the printhead
bracket.
10 Load a new supply of media and ribbon, as described earlier
in this manual.
Chapter 10 — Maintenance
101