Intermec EasyCoder PX4i User Manual page 104

EasyCoder PX4i User's Guide (IPL Version)
Large Part Of Dot Line Missing
Possible Cause
Failing printhead
Failing strobe signal
Printout Missing Along Inner Edge
Possible Cause
Bad media alignment Adjust
Using small core with
supply post in upper
position.
X-start parameter
value too low
Transfer Ribbon Breaks
Possible Cause
Ribbon not fitted
correctly
Wrong media grade
Bad energy control
Transfer Ribbon Wrinkles
Possible Cause
Faulty ribbon break
shaft adjustment
Incorrect edge guide
adjustment
Printhead pressure too
strong
Chapter 9 — Troubleshooting
Remedy
Replace printhead
Check CPU-board
Remedy
Move post to lower
position
Increase value
Remedy
Reload ribbon
correctly
Change parameter,
then clean printhead
Adjust
Remedy
Adjust
Adjust
Adjust pressure
Reference
Chapter 11
Call Service
Reference
Chapter 4
Chapter 2
Chapter 6
Reference
Chapter 5
Chapter 6,
Chapter 10
Call Service
Reference
Chapter 11
Chapter 4
Chapter 11
89