7.0 VENTING
7.1 Rear Vent Conversion Instructions
IMPORTANT: This appliance has outlets for both top and rear
venting. The unused vent exit must have the cover plates in
place, and the cover plates must be removed from the exit
according to the instructions below to be used.
NOTE: All components removed from the top vent exit will be
reinstalled for the rear vent.
7.1.1 Remove Top Vent Collars
1
REMOVE THE ATTACHMENT SCREW SECURING COVER
2
REMOVE (4) SCREWS SECURING
6⅝" (168mm) COMBUSTION AIR INTAKE COLLAR
3
REMOVE (6) SCREWS SECURING
4" (101mm) EXHAUST COLLAR
22 VENTING
7.1.2 Remove Back Vent Combustion
Air Intake and Exhaust Collars
1
REMOVE ATTACHMENT SCREW SECURING
THE BACK COVER PLATE
2
REMOVE (4) SCREWS SECURING COMBUSTION
AIR INTAKE BACK COVER PLATE
3
INSERT TABS ON OUTER COVER PLATE INTO
SLOTS ON APPLIANCE TOP. SECURE WITH (1)
SCREW PREVIOUSLY REMOVED.