20
en | Configuration
7
Configuration
7.1
Setting up the camera
Configure the settings (such as application variant, focus and
picture orientation) using one of the following methods:
–
–
Notice!
Changing the application variant overwrites your camera
settings with the factory defaults.
Note:
The Menu button on the camera is used for camera settings in
the application variants "Starlight mode" (default) and "Starlight
mode 1.3 MP". In other application variants, pressing Menu will
only switch the analog output on/off; use the web browser to
set up camera settings (focus, zoom, etc.) for these variants.
7.2
Configuration via web browser
The unit must have a valid IP address and a compatible subnet
mask to operate on your network. By default, DHCP is pre-set at
the factory to On and so your DHCP server assigns an IP
address. With no DHCP server the default address is
192.168.0.1
To view the camera in your web browser:
1.
2.
3.
Note:
2016.06 | v1.0 | AM18-Q0705
Locally using the Menu button on the camera to step
through the basic camera settings.
Via a web browser; this method also enables you to change
other camera parameters.
Start the Web browser.
Enter the IP address of the unit as the URL.
During initial installation, confirm any security questions
that appear.
DINION IP starlight 6000
Bosch Security Systems
HD