Image Selection; View Control; Digital I/O; System Log / Event Log - Bosch Dinion2X Installation And Operation Manual

Dinion2X IP Camera
10.1.2

Image selection

View the image on a full screen.
– Click the Stream 1, Stream 2 or M-JPEG tab below the
video image to switch between the different displays for
the camera image.
10.1.3

View Control

If the data port is set-up to control a PTZ device, a View Control
tab is shown and activated. Use the controls to position the
camera and to adjust zoom, focus and iris. Six pre-set positions
can be defined and selected.
Move the mouse cursor over the video image; additional options
for controlling peripherals are displayed with the mouse cursor.
10.1.4

Digital I/O

Depending on the configuration of the unit, the alarm input and
the relay output are displayed next to the camera image. The
alarm symbol is for information and indicates the input status
of the alarm input: Active 1 = Symbol lights, Active 0 = Symbol
not lit.
The relay on the camera allows the operation of a device (for
example, a light or a door opener).
– To operate, click the relay symbol. The symbol is red when
the relay is activated.
10.1.5

System Log / Event Log

The System Log field contains information about the operating
status of the camera and the connection. These messages can
be saved automatically in a file. Events such as the triggering or
end of alarms are shown in the Event Log field. These messages
can be saved automatically in a file.
To delete the entries from the fields, click the icon in the top
right-hand corner of the relevant field.
10.1.6

Saving snapshots

Individual images from the video sequence that is currently
being shown on the Livepage can be saved in JPEG format on
the computer's hard drive.
Bosch Security Systems
This manual downloaded from http://www.manualowl.com
Installation and Operation Manual
Operation via the browser | en 115
AR18-10-B006 | v1.1 | 2010.06