Extron electronics SSP 7.1 User Manual page 31

3. Click the Connect button (or Cancel to exit the program).
If you select Emulate, click on the Work Offline button (or Cancel to exit the program).
Figure 15.
"Connect to device?" Dialog Box — Emulate Mode
NOTE: When Emulate/Work Offline is selected, the Connect button is replaced by
a Work Offline button. Instead of establishing a connection with the sound
processor, the program allows you to create a configuration that can be
saved as a file and used to update the configuration of the sound processor
when the program is in Live mode.
When the program opens, you may still toggle between Live or Emulate modes by using
the buttons in the top right corner of the program window, as described on page 23 in
"Live and Emulate Modes".
If you check the "Stop prompting me to connect upon startup" box, the next time the
program opens, this dialog box is not shown and the program automatically opens in
Emulate mode. Click the Live button in the program window to switch to Live mode.
To re-enable this box, use the menu system to navigate to
(see page 53). This clears the check box in all dialog boxes and all previously disabled
pop-up messages occur regularly again.
Options>Re-enable Dialogs
SSP 7.1 • Setup and Control Software 25