Extron electronics SSP 7.1 User Manual page 56

DTS Neo:6 settings
Center Image Settings
These controls set the center image for DTS Neo:6 Cinema
and DTS Neo:6 Music listening modes. More information
about this listening mode is found on page
The sliding bars adjust the center image control settings:
•
DTS Neo:6 Cinema: 0 - 10 (the default is 10)
•
DTS Neo:6 Music: 0 - 10 (the default is 3)
Setting the control to 0 creates the effect of spreading out
the audio signal across the front speakers. Setting the control to 10 creates the effect of
centralizing the audio signal.
See page 69 for more information about
Mono Settings
Two advanced configurations apply only to mono
sources or outputs.
Analog Source (applies to Input 5 only)
A mono signal may be input as left channel only,
right channel only, or the sum of left and right
channels (both channels input identical mono
signals). These controls allow the user to decide
whether the Left Only, Right Only, or L+R (Sum) summed input becomes the source for
the mono decoding mode. The default is L + R (Sum).
Output Channel(s)
These buttons let the user select whether mono signals are output to the center
channel (Center Only) or a dual mono signal is sent to the right and left front channels
(Front L+R Only). The default is Center Only.
Input and Output information bar
The Input and Output information bar is available from all GUI tabs and is described in detail
pages 28 and 29.
on
69.
Center Image control.
SSP 7.1 • Setup and Control Software 50