Configuring the ACUIX ES
Task/Action with Default
Selecting the High or Low Light WB Mode
1.
Select 5 Camera Options > 4 White Balance >
•
1 High Light WB Mode
•
2 Low Light WB Mode
2.
Select AUTO (default) or ATW or Indoor or
Outdoor.
Selecting a Gain Setting/Shutter Speed for High or Low Light 28 dB
1.
Select 5 Camera Options > 4 White Balance >
•
3 Enter High Light 28dB
•
4 Enter Low Light 28dB
2.
Select a Gain Setting between 0 and 28 dB.
3.
Select a Shutter Speed (high light default is
1/60s; low light default is 1/30 s):
•
PAL cameras = 1/3 sec, 1/6 sec, 1/12 sec,
1/25 sec, or 1/50 sec
•
NTSC cameras = 1/4 sec, 1/8 sec, 1/15 sec,
1/30 sec, or 1/60 sec
Turning the Manual White Balance ON or OFF
•
Select 5 Camera Options > 4 White Balance > 5
Manual White Balance > ON or OFF (default).
Turning Vertical Phase Edge ON or OFF
•
Select 5 Camera Options > 6 Vert Phase Edge
> ON or OFF (default).
Setting the Vertical Phase Edge
1.
Enable the Vertical Phase Edge.
2.
Select 5 Camera Options > 7 Vert Phase 0-359
> enter a number between 0 (default) and 359 in
increments of one (1).
58
Notes
•
AUTO = avoids fixing single color scenes as
white. Auto Tracing White Balance with limitations
on R and B gain (3,200°K to 6,000°K).
•
ATW = turns the dominant color within the
temperature color range to white. Auto Tracing
White Balance (2,000°K to 10,000K°).
•
Indoor = sets the white balance to 3200°K.
•
Outdoor = sets the white balance to 5800°K.
The high light level mode cannot be set lower than the
low light level mode and conversely, the low light level
mode cannot be set higher than the high light level
mode.
If manual white balance is turned ON, the white balance
submenu items 1 to 4 are not available.