Configuring Default Functions: Presets And Tours - Honeywell ACUIX ES Installation And Configuration Manual

Configuring Default Functions: Presets and Tours

Task/Action with Default
Setting the Default Function Values
1. Select 3 Control Options > 5 Set Default
Function > enter values into each field as required:
a. From the FUN column, select P, V, or T.
This is the function that performs after being
idle for the specified delay time.
b. In the NUM column, enter the preset or preset
tour number.
c. In the DLY column, enter the MIN:SEC
(minutes:seconds) of delay before the
function is performed.
The maximum delay is 99 minutes and 59
seconds.
In the ENA column, select Y to enable or N to
d.
disable the default function.
Enabling or Disabling the Default Function After it is Set
• Select 3 Control Options > 5 Set Default
Function > select Enable or Disable.
Document 800-01949 Rev D
05/09
TM
ACUIX ES Installation and Configuration Guide
Notes
• FUN: The function displays on the screen as
PS=preset, PT=preset tour, or MT= mimic tour.
If a preset is reserved for a special function; PS =
•
PS Reserved displays.
• If the function is programmed, the text displays.
For example, if P (preset) 1 is entered,
pre-programmed and named, PS = Entrance
Door displays.
If Preset 1 is entered, but not pre programmed, PS
•
= Does Not Exist displays.
• IF disabled, THEN the unit remains at its present
position until a control command is received.
• IF enabled, and the dome is idle for the
programmed DLY (delay) setting, THEN the dome
performs the function (preset, preset tour, or
mimic tour) programmed in the default function
setup menu after the programmed delay with no
activity.
• IF contacts are present and the dome reaches the
DLY setting, THEN the unit automatically
acknowledges the current contact, resets its delay
timer, and processes the next contact in numerical
order. All contacts are processed before
performing the default function
59