Table 3-2 Special Presets Based On Protocol - Honeywell ACUIX ES Installation And Configuration Manual

Preset Function
72 Recover encrypted user login PIN and GUID
73 Enable broadcast command receive mode
74 Disable broadcast command receive mode
75 Administrator / password/PIN settings
• 1. User Login PIN
• 2. Change PIN
• 5. System Info
• 6. Change Address, Protocol
80, 81, Run mimic tours 1, 2 and 3
82
83, 84, Program mimic tours 1, 2 and 3
85
86 Stop or end mimic tour programming
sequence
87, 88, Start/run preset tours 1, 2 and 3
89
90 Setup menu (on-screen display/OSD)
91, 97 Reserved
and 99
94 and
Reserved and not available with the Sony
95
FCB EX-45C camera
92 Toggles auto exposure or iris ON and OFF
(factory default is ON)
93 Toggles backlight compensation ON and
OFF (preset 92 /auto exposure must be ON)
96 Run the Flashback function
98 Camera lens reset or cycles the power
(camera dependent)
Document 800-01949 Rev D
05/09
Note For Pelco P_AD and Pelco D_AD switch settings and special presets, see
Appendix A.
Table 3-2 Special Presets Based on Protocol
TM
ACUIX ES Installation and Configuration Guide
Protocol
All
MAXPRO-mode, VCL,
VCL UTC, Diamond and
Pelco D and P
MAXPRO-mode, VCL,
VCL UTC, Diamond and
Pelco D and P
All
MAXPRO-mode, VCL,
VCL UTC, Pelco D and P
MAXPRO-mode, VCL,
VCL UTC, Pelco D and P
MAXPRO-mode, VCL,
VCL UTC, Pelco D and P
MAXPRO-mode, VCL,
VCL UTC, Pelco D and P
MAXPRO-mode, VCL,
VCL UTC, Diamond and
Pelco D and P
MAXPRO-mode, VCL,
VCL UTC, Diamond,
Pelco D and P
MAXPRO-mode, VCL,
VCL UTC, Diamond and
Pelco D and P
MAXPRO-mode, VCL,
VCL UTC, Diamond and
Pelco D and P
MAXPRO-mode, VCL,
VCL UTC, Pelco D and P
All
Cross Reference
page 75
page 76
page 76
System Administration
and Settings, page 71
page 60
page 60
page 60
page 61
Step 4: Open the OSD
Menu and Start
Configuring, page 50
n/a
page 57
page 57
page 50
page 72
49