Table of Contents
Advertisement
3.2 Configuration Mode
3.2.1 Netw ork Setup / TCP/IP
Network/TCP/IP
①
Host Name
②
Ethernet Card
③
Mode
④
MAC Address
⑤
IP Version
⑥
IP Address
⑦
Subnet Mask
⑧
Default Gateway
⑨
Preferred DNS Server
⑩
Alternate DNS Server
⑪
Enable ARP/Ping
Description
Enter a host name for the camera up to 15 characters in length.
Not configurable. Wire is selected by default.
Select Static or DHCP. If Static is selected, you must manually assign the IP Address (IPv4/IPv6),
Subnet Mask (IPv4), and Default Gateway (IPv4/IPv6). If DHCP is selected, the settings are
assigned automatically.
Not configurable. Displays the camera's MAC address.
Select IPv4 or IPv6, depending on the IP version you are using.
If applicable, assign an IP address to the camera.
If applicable, assign a subnet mask address to the camera.
If applicable, assign a default gateway address to the camera.
If applicable, assign a primary DNS server to the camera.
If applicable, assign a secondary DNS server to the camera.
You can set or modify the camera's IP address using its MAC address. This must be done within
2 minutes of rebooting the camera.
To enable ARP/Ping to set the IP address:
1. Obtain an IP address and make sure that the camera and the PC are in the same LAN.
2. Obtain the camera's MAC address (displayed on camera label).
3. Open the Command Prompt window on your PC and type the following commands:
4. Reboot the camera. If the setup was successful, you will see something like "Reply from
192.168.0.125 ..." You can then close the Command Prompt window.
5. Close the Command Prompt window.
6. To verify that the IP address works, open your browser, type http://< IP address > in the
address bar, and then press Enter.
13
Advertisement
Table of Contents
