Contacts; Flashback; Figure 1-1 Acuix Es Hardware Components - Honeywell ACUIX ES Installation And Configuration Manual

Contacts

Flashback

Document 800-01949 Rev D
05/09
Figure 1-1 ACUIX ES Hardware Components
Housing
Lower dome
Contacts can detect a door opening or window breakage, for example. Using the on-screen
display (OSD), you can program up to four normally open or closed conditions to activate
a preset, preset tour or mimic tour. For wiring connections, see
Contact Input Wiring on page
(Optional) on page 67.
Note The term contact and alarm are used interchangeably to mean the same
thing. Alarm is displayed on the OSD, although contact is a better description
since it is not an audible alarm but a change in electrical state to the contacts
resulting in a programmed response.
Use the Flashback feature to toggle between two saved positions and quickly return to a
scene of interest.
Flashback is available using a controller. When you press Flashback, it saves the scene
(Scene A) as a Flashback. When you move to the next scene (Scene B) and press
Flashback again, it saves Scene B and returns the dome to Scene A. If the operator presses
Flashback a third time (without manually moving to a new scene), the dome returns to
Scene B. The dome only saves and toggles between two scenes at a time, except when
Flashback is used during a preset tour. See
TM
ACUIX ES Installation and Configuration Guide
Dome
39 and for OSD settings, see
Using the Flashback Preset
Pendant mounts
Connecting the Optional
Configuring Contacts/Alarms
on page 50.
15