Connecting The Optional Contact Input Wiring; Table 2-7 Contact Wiring 3 Pin; Table 2-8 Utp And Contact Wiring 9 Pin (Optional) - Honeywell ACUIX ES Installation And Configuration Manual

Connecting the Optional Contact Input Wiring

Document 800-01949 Rev D
05/09
All contact input connections MUST be passive contacts.
Note The contact cabling should not be terminated until standard operation of the
dome is tested.
The plugs for the 3- and 9-pin connections to the contact inputs are located on the scan
assembly. See Figure 2-3
the dome, they should not be connected to the contact connector until all dome
functionality has been fully tested. Contact device activations could cause confusion during
the initial testing stages.
See Tables 2-7 and 2-8 for wiring information.
TM
ACUIX ES Installation and Configuration Guide
on page 30 for the location. If contact devices are connected to
Table 2-7 Contact Wiring 3 Pin
Pin P2 (3 pin)
1 Contact input 1
2 Contact input common
3 Contact input 2
Table 2-8 UTP and Contact Wiring 9 Pin (Optional)
Pin P3 (9 pin)
1 UTP + signal
2 UTP - signal
3 Contact input 3
4 Contact input 4
5 Contact input 5
6 Contact input 6
7 Contact input 7
8 Contact input 8
9 Contact input common
39