Controller And Protocol Compatibility; Intellibus Protocol - Honeywell ACUIX ES Installation And Configuration Manual

Controller and Protocol Compatibility

IntelliBus Protocol

Document 800-01949 Rev D
05/09
Note The HJZTP Controller User Guide
Diamond protocols. The ACUIX ES default protocol is MAXPRO-mode for
NTSC and VCL RS485 protocol for PAL. When in NTSC and for the HJZTP
controller ONLY, MAXPRO-mode can be considered exactly the same as
Diamond protocol. From the user's perspective, the MAXPRO-mode allows
access to the same special presets as with the VCL protocol.
If other controllers, DVRs or protocols are used, MAXPRO-mode, Pelco P or Pelco D
protocols also operate in a similar way as described for the VCL protocol. That is to
say, how you access the special presets and on-screen display (OSD) is approximately the
same.
The ACUIX ES is compatible with the following controllers and protocols:
• HJZTP controller using the VCL or MAXPRO-mode protocols
• HMAX082/HMAX162 Matrix Switcher and HKJMMTP controller using VCL UTP / coax
control protocol
• Pelco P and Pelco D third party protocols and controllers
• HEGS5000/5001 controller using Diamond protocol
TM
• IntelliBus protocol
When ACUIX ES is network connected to a PC-based DVR (such as the Honeywell Rapid
Eye™) and set to the IntelliBus protocol, you can:
Download an ACUIX ES configuration to a PC for later use: After completing the user
programming of the dome (presets, mimic tours, preset tours, and privacy zones), you can
upload the configuration data to a PC for safekeeping.
Upload an ACUIX ES configuration to another dome of the same camera model: The
configuration can be saved on a PC and uploaded to a replacement dome if required. The
ACUIX ES configuration has camera model specific parameters so the configuration
uploads (retrieving data from a faulty dome) and downloads (sending data to a new dome)
must be between two domes with the same camera model.
Upgrade the firmware to one or more ACUIX ES PTZ domes in your network.
For detailed information about these options using the IntelliBus protocol, refer to the
Eye System Administrator Guide
TM
ACUIX ES Installation and Configuration Guide
indicates it can be set to either VCL or
and the Rapid Eye Installation Guide.
Rapid
19