Setting The Rs485 Control Data Termination (Sw5); Setting The Dome Address (Sw4); Table 2-4 Dip Switch Protocol Settings (Sw3 1 - 5) - Honeywell ACUIX ES Installation And Configuration Manual

Setting the RS485 Control Data Termination (SW5)

Setting the Dome Address (SW4)

Document 800-01949 Rev D
05/09
Protocol Name
IntelliBus
MAXPRO-mode
VCL - RS485
VCL UTC
Pelco P
Pelco D
Diamond
1. Locate SW5. See Figure
2. If required, change from the default and carefully place the SW5 switch in the required
termination position:
• (Default) Not terminated: Switch OFF (away from ON).
• Terminated in 120 Ohm: Switch ON.
Note Each dome requires a unique address. The ACUIX ES can be addressed from
001 to 255. The default address is 001.
1. Locate SW4. See Figure
• Carefully place the SW4 switch in the required ON/OFF positions based on the
dome address. See
Figure 2-2 for a DIP switch example.
TM
ACUIX ES Installation and Configuration Guide
Table 2-4 DIP Switch Protocol Settings (SW3 1 - 5)
Switch Positions
1 2
OFF OFF
OFF ON
ON ON
OFF OFF
ON OFF
OFF ON
ON OFF
2-1.
2-1.
Table 2-5 for a partial list of the address settings and
3 4 5
OFF OFF OFF
OFF OFF OFF
OFF OFF OFF
ON OFF OFF
ON OFF OFF
ON OFF OFF
OFF OFF OFF
35