Day/Night Settings; Configuring Video Settings; Mode; Figure 4-3 Mode - Honeywell 60 Series Configuration Manual

Day/Night Settings

Switch to B/W in night mode: Check to enable the camera to automatically switch to
Black/White during night mode.

Mode:

•
Auto mode (The Day/Night Exposure Profile will not be available if Auto mode is selected)
The camera automatically removes the filter by judging the level of ambient light.
Note
Select auto mode will disable profile of exposure settings.
•
Day mode
In day mode, the camera switches on the IR cut filter at all times to block infrared light
from reaching the sensor so that the colors will not be distorted.
•
Night mode
In night mode, the camera switches off the IR cut filter at all times for the sensor to accept
infrared light, thus helping to improve low light sensitivity.
•
Schedule mode
The camera switches between day mode and night mode based on a specified schedule.
Enter the start and end time for day mode. The time format is [hh:mm] and is expressed in
24-hour clock time. By default, the start and end time of day mode are set to 07:00 and
18:00.
Sensitivity: Adjust the responsiveness of the IR filter to lighting conditions as Low, Normal, or
High.

Configuring Video Settings

Go to Setup Camera Setup  Video.
This section describes how to configure viewing window and video streaming properties
(format, resolution, frame rate, bit rate, I-frame interval, etc.).
Mode
Go to Setup Camera Setup  Video Mode.

Figure 4-3 Mode

Configuring Camera Settings
19