Figure 2-9 In Ceiling Scan Assembly With Switch, Plugs And Bnc Connector - Honeywell ACUIX ES Installation And Configuration Manual

Installing the ACUIX ES
44
d. Using the mounting template, cut a 7 5/8" (194 mm) diameter hole in the ceiling
tile flush with the hole in the center of the plate.
3. If required, secure a safety cable to a building support
structure. Attach the safety cable (from the building
support structure) to the outside of the housing by:
a. Threading the safety cable through a looping
sleeve,
b. Attach to the safety cable bracket on the
housing,
c. Back through the looping sleeve, and then
d. Crimp the looping sleeve to secure the safety
cable.
4. Unsnap/remove the cable can and complete
5. Finish connecting the wiring to the outside of the scan assembly housing
a. Remove the plugs and screw the applicable wires into the plug holes.
b. Press the plugs back into the holes.
c. Optional Connect BNC (for coax).
6. Pull all the wiring from the plugs through the cable can wiring hole. Ensure the wiring
extends at least 12 inches (305 mm) past the end of the hole and cut the cable length
to 6 inches (152 mm).
7. Tighten the wire clamp to hold the wires in place (see
8. Snap the cable can back into place by inserting the two tabs on the cable can into the
two holes on the scan assembly housing to secure it. See
Figure 2-9 In Ceiling Scan Assembly with Switch, Plugs and BNC Connector
BNC connector
SW1 and Plugs 1, 2 and 3
9. Insert the cable can and housing through the hole in the ceiling.
a. Turn the wing tab turning screws to make sure the space between the wing tabs
on the housing and the housing flange is greater than the thickness of the ceiling.
See Figure 2-8.
• To increase the space, turn the screw clockwise.
• To decrease the space, turn the screw counterclockwise.
Housing safety cable
bracket
Setting the Switches on page 28.
Figure 2-8).
Figure 2-9.
Cable can with tabs
(Figure 2-9):