Table 2-1 Default Dip Switch Settings For Ntsc Or Pal Camera Models - Honeywell ACUIX ES Installation And Configuration Manual

Setting
Baud rate
Parity
Protocol
Address
RS485 Termination
Video Selection
Miscellaneous Defaults*
Reserved
Restore Factory Defaults
Overriding the Logical
Address
Reserved
Debugging/boot control
* These are advanced switch settings and it is not recommended to make changes to these defaults. See
System Administration and Settings
Document 800-01949 Rev D
05/09
Note NTSC or PAL settings are camera model dependent. See
Dome Models, page
Table 2-1 Default DIP Switch Settings for NTSC or PAL Camera Models
NTSC Defaults
9600
Even
MAXPRO-mode
1
Not Terminated (OFF)
COAXIAL Video
Enabled (OFF)
OFF
OFF
ON
OFF
OFF
on page 71 for more information.
TM
ACUIX ES Installation and Configuration Guide
17 for a list of available NTSC or PAL cameras.
PAL Defaults
9600
No parity
VCL 485
1
Not Terminated (OFF)
COAXIAL Video
Enabled (OFF)
OFF
OFF
ON
OFF
OFF
Table 1-2 ACUIX ES
Switch and Available
Positions
SW2 (1 to 4)
SW2 (5 and 6)
SW3 (1 to 5)
SW4 (1 to 8)
SW5
SW1
SW3 (6)
SW3 (7)
SW3 (8)
SW2 (7)
SW2 (8)
31