Restoring Factory Defaults; Resetting The Camera Lens - Honeywell ACUIX ES Installation And Configuration Manual

System Administration and Settings

Restoring Factory Defaults

Resetting the Camera Lens

72
There are two types of factory defaults that can be restored either directly on the dome
using a DIP switch or via the OSD Diagnostic Options menu. There is an important
distinction between the two.
• Using the OSD menu restores all of the camera and dome configuration settings to
the factory defaults, but DOES NOT delete user programmed configurations (presets,
preset tours, mimic tours, sectors and privacy zones).
• Using DIP switch SW3-7 restores all the settings to defaults and DOES delete any
user programmed configurations (presets, preset tours, mimic tours, sectors and
privacy zones).
Restoring Defaults Using the OSD
• Select 4 Diagnostic Options > 6 Restore Default Settings > Y or N to cancel.
The message This will restore all user default settings to their
default values displays.
All of the default configuration settings are restored to the factory defaults, without
deleting user programmed configurations (presets, preset tours, mimic tours, sectors
and privacy zones).
Restoring to Factory Defaults Using Switch SW3-7
Note The switch is read only at power up. See
Locations on page
1. Locate switch SW3-7.
2. Carefully place the switch in the required position.
• (Default) Normal operation: Select OFF.
• To restore factory default settings and delete any user programmed
configurations (presets, preset tours, mimic tours, sectors and privacy zones):
Select ON.
3. After the factory default is restored, set switch back to OFF position to prevent
unwanted deletion of user programmed configurations.
• Press 98 > Preset.
DIP Switch Default Settings and
28 for more information.