Configuring Privacy Zones; Table 3-5 Privacy Zone Functions - Honeywell ACUIX ES Installation And Configuration Manual

Configuring Privacy Zones

Task/Action with Default
Programming a Privacy Zone
1. Position the dome so the area to be covered by
the privacy zone is on the monitor.
2. Select 6 Function Programming > 6 Program
Privacy Zone.
3. Enter the 4 digit PIN. The default is 1000.
4. Select a privacy zone number between 1 and 24
to assign the area.
5. Press Focus Far (-) to switch to PTZ mode to gain
control over the joystick. Adjust the coordinates of
the privacy zone as required using the joystick
and moving it up or right to create a mask/box.
The tilt cannot be greater than 70° and the zoom
cannot be more than 1x.
6. Press Focus Near (+) to switch to menu mode to
access the controller keyboard. Press Iris Open
(+) to save the coordinates.
7. Program another privacy zone or exit.
Changing the Privacy Zone Mask Color
1. Select 6 Function Programming > 3 Privacy
Zone Options > 3 Privacy Zone Color.
2. Select the color of the mask, Black, Grey or
White.
Document 800-01949 Rev D
05/09
Note When setting up privacy zones with the Sony FCB EX-45C camera, the
coordinates displayed on screen prior to saving increase by four times (4x)
once saved. In other words, a 1x1 square on screen is saved and displays as
a 4x4 square for that privacy zone.
Also see Resetting a Privacy Zone Password (Diamond or IntelliBus Only)
• If a unit is sent to a preset and any portion of a privacy zone would be visible while
traveling to the preset, the video is masked with a box where any portion of a privacy
zone is visible.
• To prevent any privacy zones being visible if the dome loses power, the video is
blanked upon power-up until the dome finds home.
Table 3-5 Privacy Zone Functions
TM
ACUIX ES Installation and Configuration Guide
Notes
• This menu is not available with IntelliBus protocol.
• Privacy zones are assigned a priority between 1
and 24 in the order programmed. For example, if
user programs Zone 24 before Zone15, Zone 24 is
a Priority 1 and Zone 15 is a Priority 2.
• If a privacy zone is disabled, it does not display on
the PTZ Priority Menu.
• When a privacy zone is enabled, it is assigned the
highest unused priority available.
• Up to 24 privacy zones can be programmed.
• For the Sony FCB EX-45C camera, the
coordinates displayed on screen prior to saving
increase by four times (4x) once saved. In other
words, a 1x1 square on screen is saved and
displays as a 4x4 square for that privacy zone.
on page 76.
63