Step 4: Open The Osd Menu And Start Configuring - Honeywell ACUIX ES Installation And Configuration Manual

Configuring the ACUIX ES

Step 4: Open the OSD Menu and Start Configuring

50
Accessing Special Presets
• Press [preset number] > Preset button on the controller.
Using the Flashback Preset
• Press 96 > Preset to toggle between two saved positions and quickly return to a
scene of interest.
Note The availability of OSD menus is based on the protocol (MAXPRO-mode,
VCL, VCL UTC, Diamond, Pelco P or Pelco D) and the camera model. See
Important Information About Protocols
Note If the PIN feature is enabled (see
75), the Login screen displays and a PIN is required to access the OSD.
1. Enter a PIN or skip to step 2.
a. If prompted, enter the 4-digit PIN to log in as User Level 1 (the default is 1000).
Move the joystick up or down to select numbers for each digit. Move the joystick
left or right to move between digits.
b. Press F5 (enter).
2. Press 90 > Preset.
The main OSD menu, including the camera model, displays after entering the setup
menus.
3. Open the submenus or select a menu:
• Press a number beside the menu option. The numbers either toggle between the
available choices or opens another menu.
• Move the joystick up or down the menu and press F5 (enter).
4. Configure the dome as required using
on page 18.
Working with Passwords and PINS
Figure 3-1 and the following instructions.
on page