Configuring Mimic Tours; Table 3-3 Mimic Tour Functions - Honeywell ACUIX ES Installation And Configuration Manual

Configuring the ACUIX ES

Configuring Mimic Tours

Task/Action with Default
Programming a Mimic Tour
1. Select the applicable preset number or use the
function programming menu:
• 83 > Preset to create mimic tour 1.
• 84 > Preset to create mimic tour 2.
• 85 > Preset to create mimic tour 3.
2. During the 120 second countdown, pan and tilt
the dome and adjust the lens zoom setting as
required.
3. To end the programming mode, either wait for the
countdown to reach 0 or press 86 > Preset.
Running a Mimic Tour
1. Program a mimic tour.
2. Select the applicable preset number or use the
function programming menu:
• 80 > Preset to run mimic tour 1.
• 81 > Preset to run mimic tour 2.
• 82 > Preset to run mimic tour 3.
Stopping a Mimic Tour
• Stop any mimic tour by manually controlling the
dome or by sending the dome to a preset, preset
tour, or another mimic tour command.
Deleting a Mimic Tour from the Function Programming Menu
1. Select 6 Function Programming > 7 Delete
PS/PT/MT/Sectors.
2. Locate and select the applicable mimic tour (MT).
The message Delete Success displays or if the
selected function and number is not programmed,
the message Does Not Exist displays instead.
60
Table 3-3 Mimic Tour Functions
Notes
The dome stores the commands in the order performed
during the 120 seconds (two minutes).
Up to three mimic tours can be programmed.
Existing programming does not have to be deleted to
be reprogrammed. You can edit the coordinates for an
existing mimic tour by following the applicable
programming procedures.