Advertisement
Connecting the Camera
1.
Connect the BNC video output connector to the video-in
connector on your monitor or video recorder.
2.
Connect the camera to a power supply appropriate for your
installation (12 VDC or 24 VAC).
Programming
OSD Menu Structure
The HCD92534 menu system consists of one main SETUP MENU
(see Camera Controller on page 2) for easy camera
programming.
Press down on the SETUP (MENU) control (see Menu Structure
below) to display the SETUP menu.
Menu Structure
<<SETUP MENU>>
1
LENS
DC!
2
SHUTTER
– – –
3
WHITE BAL.
ATW
4
BACKLIGHT
OFF
5
AGC
MIDDLE!
6
DNR
MIDDLE
7
DSS
OFF
8
SPECIAL!
9
EXIT MENU
LENS
SHUTTER
WHITE BAL.
BACKLIGHT
SETUP
MENU
AGC
DNR
DSS
SPECIAL!
EXIT MENU
© 2007 Honeywell International Inc. All rights reserved. No part of this publication may be reproduced by any means without written permission from Honeywell Video
Systems. The information in this publication is believed to be accurate in all respects. However, Honeywell Video Systems cannot assume responsibility for any
consequences resulting from the use thereof. The information contained herein is subject to change without notice. Revisions or new editions to this publication may
be issued to incorporate such changes.
SETUP
MENU
! indicates submenus
DC! , VIDEO, MANUAL
FLK, ESC! , MANUAL
ATW, MANUAL! , AWC!
OFF, LOW, MIDDLE, HIGH
OFF, LOW! , MIDDLE! , HIGH!
OFF, LOW, MIDDLE, HIGH
!
OFF, AUTO
Frequently Asked Questions
After adjusting the camera settings using the menu, I don't
have any video. What might have gone wrong?
Check that the LENS is set to DC on the menu, as this is the only
type of lens that is currently supported.
There appears to be blurred motion on the video. How do I
turn this off?
Go to DSS and change it to OFF.
It is dark outside, but the camera is still in day mode, and
the IR LEDs are not on.
Change the LUX LEVEL DIP Switches to a higher level (Steps 1 or
2). This will force the camera to switch over to night mode at a
higher light setting.
Also confirm that there is no external light source nearby that may
be in the view of the camera and/or the light sensor on the front of
the camera.
When the camera goes into night mode, the picture is
over exposed, as there is too much IR Light. How do I
reduce the intensity of the IR Light?
Adjust the LED LEVEL adjustment screw by rotating it counter-
clockwise to reduce the intensity.
I have the camera set to the widest field of view, but in
night mode the middle portion of the picture is brighter
than the edges. Is this normal?
Yes, the 2.8–10mm lens has a wider field of view than the infrared
LEDs can project, and therefore, the center will be brighter than
the edges. You can reduce the angle of view of the lens using the
zoom and focus controls or reduce the intensity of the IR LEDs as
described above.
I need to detect objects moving beyond the edge of
illumination. How can I increase the camera's low light
sensitivity?
Set the DSS control to Auto and choose X2, X4 or X8 on the
setting. This will improve the detection of faraway objects that may
be out of range of the IR LEDs. There may be slight motion blur of
fast moving objects.
www.honeywellvideo.com
+1.800.796.CCTV (North America only)
HVSsupport@honeywell.com
Document 800-00273 - Rev A - 04/07
Advertisement
