Setting Up Live Video Streaming; Setting The Stream Type; Setting The Stream Protocol; Logging Out Of The Web Client - Honeywell equIP Series User Manual

2MP/4MP Low Light WDR IP Camera User Guide
Alarm Output
Help

Setting Up Live Video Streaming

In the upper right corner of the screen, immediately above the video window, you can set the
stream type and protocol for live video streaming.

Setting the Stream Type

To set the stream type, in the Stream Type list, select Main Stream, Sub Stream 1, or Sub
Stream 2.
Main Stream
Sub Stream 1
Sub Stream 2
The properties for each stream type are configured on the Setup > Compression Setup >
Video page (see

Setting the Stream Protocol

To set the stream protocol, in the Protocol list, select TCP, UDP, or Multicast.
TCP
UDP
Multicast

Logging Out of the Web Client

To log out of the web client, in the upper right corner of the screen, click Logout.
8
Click to generate or cancel an alarm output. The icon
appears red when the alarm is active, gray when the alarm
is inactive.
Displays online help for the Live interface.
Delivers high definition video for real-time monitoring, recording, and
storage. Uses the most bandwidth.
Delivers low/standard definition video, typically for remote monitoring
in lower network bandwidth environments.
Delivers low, standard, or high definition video.
Configuring Streaming Settings
Provides most reliable data transmission. Higher latency and bandwidth
use than UDP.
Provides fastest data transmission. Lower latency and bandwidth use
than TCP but allows some data loss (such as dropped frames).
Provides the most efficient use of bandwidth if large numbers of clients
are viewing the video simultaneously.
on page 18).