Table 4-3 Special Presets Based On Protocol - Honeywell ACUIX Installation And Configuration Manual

Before You Begin Configuring
Preset Function
72 Recover encrypted user login PIN and GUID
73 Enable broadcast command receive mode
74 Disable broadcast command receive mode
75 Administrator / password/PIN settings
•
•
•
•
76 Run Mimic Tour 1–16
77 Program Mimic Tour
78 Run Preset Tour 1–16
80, 81, 82 Run mimic tours 1, 2 and 3
83, 84, 85 Program mimic tours 1, 2 and 3
86 Stop or end mimic tour programming sequence
87, 88, 89 Start/run preset tours 1, 2 and 3
90 Setup menu (on-screen display/OSD)
91, 97 and 99 Reserved
92 Toggles auto exposure or iris ON and OFF
(factory default is ON)
93 Toggles backlight compensation ON and OFF
(preset 92 /auto exposure must be ON)
68
Note The text displayed on the OSD with MAXPRO-mode is a shortened version of
the descriptions in
Various presets are available for programming with all protocols with exceptions as noted.
Table 4-3 Special Presets Based on Protocol
1. User Login PIN
2. Change PIN
5. System Info
6. Change Address, Protocol
Table 4-3.
Protocol
All
MAXPRO-mode, VCL, VCL UTC, Diamond,
Pelco D or P
Pelco P_AD or Pelco D_AD (depending on
the hardware installation)
All
MAXPRO-mode, VCL, VCL UTC, Pelco D or P
MAXPRO-mode, VCL, VCL UTC, Pelco D or P
Pelco P_AD or Pelco D_AD (depending on
the hardware installation)
MAXPRO-mode, VCL, VCL UTC, Pelco D or P
MAXPRO-mode, VCL, VCL UTC, Pelco D or P
Pelco P_AD or Pelco D_AD (depending on
the hardware installation)
MAXPRO-mode, VCL, VCL UTC, Diamond,
Pelco D or P