Icom ID-800H Instruction Manual page 61

z Push [VFO/LOCK] to select VFO mode for
SCAN
full/programmed scan; push [MR/CALL] to se-
2
lect memory mode for memory scan.
• Push [FUNC] then [
SET
for bank scan.
B
x Push [
D(MUTE)] or [
Y Y
SQL
set the squelch to the point where noise is just
muted.
c Push [
2(T-SCAN)] to start the scan.
SCAN
• Push and hold [Y Y ] or [Z Z ] for 1 sec. also starts the
scan.
v Push [
B(D-OFF)] to switch full and pro-
SET
grammed scan (P1, P2, P3, P4 and P5), if VFO
is selected in step z.
b To stop the scan push [
[ A(MW)].
CLR
1(BANK)] to select a bank
MONI
#(16KEY-L)] to
Z Z
SQL
2(T-SCAN)] or
SCAN
SCAN OPERATION
NOTE: When AM, FM or DV mode frequencies are pro-
grammed into memory channels disorderly, memory scan
takes a lot of time (very slow). Because changing modes
takes a time. In this case, assign the AM, FM and DV
mode frequencies into the separate bank respectively. And
using the bank scan is helpful.
7
7
44