Icom ID-800H Instruction Manual page 88

11
DIGITAL MODE OPERATION
z Push [
SET
SET
• Push [Y Y ] or [Z Z ] to select "CALLS," if necessary.
B
x Push [
SET
times to select the call sign item, then push
[BAND].
• "RPT1 C" or "RPT2 C" appears for repeater call sign.
c Push [Y Y ] or [Z Z ] to select the desired call sign
channel.
• "r01" to "r54" appears.
v Push [BAND] for 1 sec. to enter call sign pro-
gramming mode.
• The 1st digit blinks.
b Push [Y Y ] or [Z Z ] to select the desired character or
code.
• Push [
SET
cursor right or left respectively.
n Push [
SET
push [Y Y ] or [Z Z ] to select the desired character or
code.
• The 2nd digit blinks (1st digit stops blinking).
• Repeat this step for programming other station call
signs.
m Push [BAND] for 1 sec. to save the call sign.
, Push [Y Y ] or [Z Z ] to select an another channel
from "r01" to "r54."
. Repeat v to m to program other station call sign
channels.
⁄0 Push [
CLR
71
B(D-OFF)] to enter call sign set mode.
B(D-OFF)] or [ C(T-OFF)] several
ENT
B(D-OFF)] or [ C(T-OFF)] to move the
ENT
B(D-OFF)] to select 2nd digit, then
A(MW)] to exit call sign set mode.
NOTE: During the call sign programming mode (v to n),
push [VFO/LOCK] to clear the entered call sign
returns to the 1st digit position)
select the previously saved call sign.
IMPORTANT! The "!" indicator appears when the se-
lected call sign channel is used for some memory or call
channels. The desired call sign can be over-written even
the "!" indicator is displayed, however, "MR ✱" is dis-
played while [BAND•MOD]
(or [BAND])
previously memorized setting in memory or call channels
are also changed at the same time.
(the cursor
, push [VFO/LOCK] again to
is pushed and the