Icom ID-800H Instruction Manual page 100

11
DIGITAL MODE OPERATION
z Push [
SET
SET
mode.
B
• Push [Y Y ] or [Z Z ] to select "MESSAG" if necessary.
x Push [
SET
times to select "TXM-C."
c Push [BAND] then push [Y Y ] or [Z Z ] to select the
message channel.
• One of either "C1" to "C6" blinks.
v Push [BAND] for 1 sec. to enter message pro-
gramming mode.
• The 1st digit blinks and channel indicator stops blink-
ing.
b Push [Y Y ] or [Z Z ] to select the desired character.
• Push [
SET
cursor right or left, respectively.
n Push [
SET
push [Y Y ] or [Z Z ] to select the desired character.
• 2nd digit blinks and 1st digit stops blinking.
• Repeat this step for programming.
m Push [BAND] for 1 sec. to save the message.
, Repeat steps x to m to set another message
channels.
. Push [
CLR
83
B (D-OFF)] to enter message set
B(D-OFF)] or [ C (T-OFF)] several
ENT
B(D-OFF)] or [ C(T-OFF)] to move the
ENT
B(D-OFF)] to select the 2nd digit, then
A(MW)] to exit the message set mode.
• Available characters
(space) (!) (") (#) ($)
(+) (,) (–) (.) (/)
(:)
(6) (7) (8) (9)
(E)
(A) (B) (C) (D)
(L) (M) (N) (O) (P)
(W) (X) (Y) (Z) ([)
(%) (&) (') (( ) ( )) (✱)
(0) (1) (2) (3) (4) (5)
(>) (?)
(;) (<) (=) (@)
(F) (G) (H) (I) (J) (K)
(Q) (R) (S) (T) (U) (V)
(\) (]) (^)