Configuring Dome Control; Setting Pass - Honeywell EQUIP Series Installation And Configuration Manual

Configuring Dome Control

Setting PASS

Document 800-04194V1 Rev A
07/11
This chapter contains the following sections:
• Setting PASS, page
• Setting Auto Pivot, page
• Setting the Pan and Tilt
• Setting Pan Reverse, page
• Setting Tilt Reverse, page
• Setting the Tilt Limit, page
• Finding Home on Startup, page
• Setting the Pan Offset, page
• Setting the Startup State
• Setting Auto Focus, page
• Setting Timed Auto
PASS adjusts the pan and tilt speed in proportion to the amount of zoom so that
the image on the screen appears to be moving at the same speed when
zooming in and out. When PASS is enabled, the pan and tilt speed is slowed at
telephoto zoom settings, making it easier to position the camera.
To enable/disable PASS:
1. From the OSD main menu, press 3 to select Control Options.
2. Press 1 to set PASS to ON (default) or OFF.
43
44
Speed, page 44
45
45
45
46
46
Restore, page 47
48
Focus, page 48
6
43