Configuring Ptz Control; Setting Pass - Honeywell ACUIX User Manual

Configuring PTZ Control

Setting PASS

Document 800-05662V1 Rev A
04/11
This chapter contains the following sections:
• Setting PASS, page
• Setting Auto Pivot, page
• Setting the Pan and Tilt
• Setting Pan Reverse, page
• Setting Tilt Reverse, page
• Setting the Tilt Limit, page
• Finding Home on Startup, page
• Setting the Pan Offset, page
• Setting the Startup State
• Setting Auto Focus, page
• Setting Timed Auto
PASS adjusts the pan and tilt speed in proportion to the amount of zoom so that
the image on the monitor appears to be moving at the same speed when
zooming in and out. When PASS is enabled, the pan and tilt speed is slowed at
telephoto zoom settings, making it easier to position the camera.
To enable/disable PASS:
• Select 3 Control Options
23
24
Speed, page 24
24
25
25
25
26
Restore, page 27
27
Focus, page 28
 
1 PASS ON (default) or OFF.
5
23