Honeywell EQUIP Series Installation And Configuration Manual page 124

System Administration and Equipment Handling
Configuring the User Login PIN
104
To enable/disable the user login PIN:
1. Click the Live View tab.
2. In the PTZ Settings panel, in the Preset Details box, type 75, and then
click Goto.
3. Using the PTZ controls, enter the 4-digit PIN (default = 1000), and then
click Iris Open.
4. Click Iris Open to set user login PIN to Enabled or Disabled (default).
To change the user login PIN:
1. Click the Live View tab.
2. In the PTZ Settings panel, in the Preset Details box, type 75, and then
click Goto.
3. Using the PTZ controls, enter the 4-digit PIN (default = 1000), and then
click Iris Open.
4. Using the down arrow on the PTZ controls, select 2 Change PIN, and then
click Iris Open.
5. Using the PTZ controls, enter a new PIN, and then click Iris Open.
6. Re-enter the PIN and then click Iris Open.
To recover a lost user login PIN:
1. Click the Live View tab.
2. In the PTZ Settings panel, in the Preset Details box, type 72, and then
click Goto.
3. Write down the numbers that appear on the screen.
4. Contact Honeywell Technical Support to recover the PIN.
To reset the privacy zone password (IntelliBus™ or Diamond protocol
only):
1. Click the Live View tab.
2. In the PTZ Settings panel, in the Preset Details box, type 75, and then
click Goto.
3. Using the PTZ controls, enter the 4-digit PIN (default = 1000), and then
click Iris Open.
4. Using the down arrow on the PTZ controls, select 3 Reset Privacyzone
Password, and then click Iris Open.
The following message appears:
EXTREME CAUTION: This will reset the privacy zones password.
Are you sure you want to do this? Y/N