Restoring The Default Settings - Honeywell EQUIP Series Installation And Configuration Manual

Restoring the Default Settings

Document 800-04194V1 Rev A
07/11
®
EQUIP Series ACUIX™ IP PTZ Dome Installation and Configuration Guide
The dome can be restored to factory default settings using either the OSD menu
or the reset button (SW1) on the housing interface board. However, there is an
important distinction between the two methods.
• Using the OSD menu restores all of the camera and dome configuration
settings to the factory defaults, but DOES NOT delete programmed
functions such as presets, preset tours, mimic tours, sectors, and privacy
zones.
• Using the reset button restores all the camera settings to factory defaults
and DOES delete programmed functions such as presets, preset tours,
mimic tours, sectors, and privacy zones.
To restore default settings using the OSD:
1. From the OSD main menu, press 4 to select Diagnostic Options.
2. Press 6 to select Restore Default Settings.
The following message appears:
Caution: This will restore all user defined settings to their
default values. Are you sure that you want to do this? Y/N
3. Select: Y (yes) to continue, or select N (no) to cancel.
To restore default settings using the reset button:
• Locate SW1 on the housing interface board and hold it down for three
seconds.
When LED2 starts to blink, the dome reboots and all configurations,
compression settings, and passwords are restored to their factory defaults.
107