Installing An In-Ceiling Housing; Figure 2-5 In-Ceiling Housing - Honeywell EQUIP Series Installation And Configuration Manual

Installing an In-Ceiling Housing

Safety Cable Bracket
Wing Tab Screw
Document 800-04194V1 Rev A
07/11
®
EQUIP Series ACUIX™ IP PTZ Dome Installation and Configuration Guide
You can install an in-ceiling housing into a dropped (suspended) ceiling or into
a hard ceiling. For dropped ceiling installations, use a separately ordered ceiling
plate (Honeywell part number 517082-7130).
You may also require the following items (not supplied):
• Safety cable (1) — 3/32-inch (2.4 mm) diameter plastic coated aircraft cable
is recommended
• Crimping loop sleeves (2)
• Adhesive tape or a plastic channel (for hard ceilings only)
Figure 2-5 In-Ceiling Housing
Wiring Access Hole
To install an in-ceiling housing in a dropped ceiling:
1. Select the location where you want to install the housing and remove the
ceiling tile.
2. Place the ceiling tile inside the supplied ceiling plate (see
the edges of the tile so that the tile fits snugly against the plate.
3. Cut a hole in the ceiling tile to match the hole in the ceiling plate.
Wing Tab
Figure 2-6). Trim
9