Figure 2-11 Alarm Input Connections - Honeywell EQUIP Series Installation And Configuration Manual

Installing the Housing
16
To connect the power cable (24 V AC):
1. Unplug terminal block J1 from the interface board.
2. Loosen the terminal block screws.
3. Insert a ground wire into the center slot marked
4. Insert the power wire leads into the slots marked "AC" on the terminal block.
5. Tighten the screws on the terminal block to secure the wires in place.
6. Plug the terminal block into the interface board.
To connect the network cable:
• Plug the network cable into the Ethernet port on the interface board.
To connect up to four alarms:
1. Unplug terminal block J6 from the interface board.
2. Loosen the terminal block screws.
3. Insert (from left to right):
a. the first wire pair into the slots marked "A1" and "CM"
b. the second wire pair into the slots marked "CM" and "A2"
c. the third wire pair into the slots marked "A3" and "CM"
d. the fourth wire pair into the slots marked "CM" and "A4"
Figure 2-11 Alarm Input Connections
ALRM1 ALRM2
A1 CM A2
4. Tighten the screws on the terminal block to secure the wires in place.
5. Plug the terminal block into the interface board.
Note All alarm input connections must be passive contacts.
ALRM3 ALRM4
A3 CM A4
.