Setting Field Noise Reduction; Setting White Balance - Honeywell EQUIP Series Installation And Configuration Manual

Setting Field Noise Reduction

Setting White Balance

Document 800-04194V1 Rev A
07/11
®
EQUIP Series ACUIX™ IP PTZ Dome Installation and Configuration Guide
To enable/disable high sensitivity mode:
1. From the OSD main menu, press 5 to select Camera Options.
2. Press 3 to select Video Setup.
3. Press 8 to set high sensitivity mode to ON or OFF (default).
Field noise reduction (FNR) technology minimizes random noise and
after-images generated by moving subjects, producing clear, sharp images and
improving motion detection performance. Field noise reduction can also reduce
the bandwith and storage volume required if the video is digitized and
compressed. Auto and manual field noise reduction modes are available.
To set the field noise reduction mode:
1. From the OSD main menu, press 5 to select Camera Options.
2. Press 3 to select Video Setup.
3. Press 9 to select Field Noise Reduction.
4. Press 1 to set field noise reduction mode to Auto (default) or Manual.
• If Auto is selected, you can adjust the level of noise reduction by setting
Auto FNR to Slight (default), Weak, Medium, or Strong.
• If Manual is selected, you can adjust the level of noise reduction by
selecting Manual FNR (O–16), and then entering a value from 0 (weak)
through 16 (strong).
If manual white balance is enabled, the red and blue gain settings can be
changed. If manual white balance is disabled, the red and blue gain settings can
be changed but the settings do not take affect until the manual white balance is
enabled again.
To enable/disable manual white balance:
1. From the OSD main menu, press 5 to select Camera Options.
2. Press 4 to select White Balance.
3. Press 1 to set manual white balance to ON or OFF (default).
67