Table 10-1 Video Resolution; Setting The Video Resolution; Setting The Frame Rate - Honeywell EQUIP Series Installation And Configuration Manual

Configuring Video

Setting the Video Resolution

Setting the Frame Rate

Setting the Priority
94
ACUIX™ IP video is available in three resolutions: CIF, 2CIF, and 4CIF. CIF is the
lowest resolution and 4CIF is the highest (see
resolution is set to 4CIF.

Table 10-1 Video Resolution

Format NTSC Resolution
CIF 352 × 240 pixels
2CIF 704 × 240 pixels
4CIF 704 × 480 pixels
To set the video resolution:
1. Click the Compression Settings tab.
2. In the Compression Settings panel, in the Resolution box, select one of
the following:
• 4CIF (default)
• 2CIF
• CIF
3. Click Apply.
To set the frame rate:
1. Click the Compression Settings tab.
2. In the Compression Settings panel, in the Frame Rate box, select a value
from 1 to 30 (NTSC, default = 30) or from 1 to 25 (PAL, default = 25).
3. Click Apply.
You can set either Quality or Bit Rate as the priority.
If Quality is selected, when the target bit rate exceeds the maximum bit rate
value, the camera prioritizes picture quality over adjusting the frames to maintain
the bit rate below the maximum bit rate value.
If Bit Rate is selected, when the target bit rate exceeds the maximum bit rate
value, the camera prioritizes adjusting the frames to maintain the bit rate below
the maximum bit rate value.
Table 10-1). By default, the video
PAL Resolution
352 × 288 pixels
704 × 288 pixels
704 × 576 pixels