Installing The Housing; Installing Mounts And Adapters; Table 2-2 Maximum Cabling Distances - Honeywell EQUIP Series Installation And Configuration Manual

Cabling Requirements

Installing Mounts and Adapters

Document 800-04194V1 Rev A
07/11
®
EQUIP Series ACUIX™ IP PTZ Dome Installation and Configuration Guide
You can power ACUIX IP domes using 12 to 22 gauge 2-conductor solid or
stranded copper wire. A Category 5 or better Ethernet cable with RJ45
connectors is required to connect the dome to a network. Alarm contacts should
use 20 gauge unshielded twisted pair (UTP) cabling.
The following table lists the recommended maximum cabling distances by cable
type:

Table 2-2 Maximum Cabling Distances

Cable Type Description
22 AWG
20 AWG
18 AWG
Power
16 AWG
14 AWG
12 AWG
Category 5 or
Network
better
Alarm 20 AWG UTP
WARNING All installations must be performed by qualified
technical personnel and must be in accordance with all national and
local mechanical and electrical codes.
WARNING Ensure that mounting surface and installation
hardware can hold the combined weight of the mount, housing, scan
assembly, and bubble.
Indoor Housing
(24 V AC @ 2.0 A)
37 ft. (11.3 m)
59 ft. (18.0 m)
94 ft. (28.7 m)
149 ft. (45.4 m)
238 ft. (72.5 m)
378 ft. (115.2 m)
328 ft. (100 m)
10,000 ft. (3048 m)
Outdoor Housing
(24 V AC @ 2.6 A)
29 ft. (8.8 m)
45 ft. (13.7 m)
72 ft. (21.9 m)
115 ft. (35.1 m)
183 ft. (55.8 m)
291 ft. (88.7 m)
5