Installing The Scan Assembly; Installing The Bubble; Figure 3-3 Acuix Scan Assembly - Honeywell EQUIP Series Installation And Configuration Manual

Installing the Scan Assembly

Installing the Scan Assembly

Installing the Bubble

20
After you have set the dome address, protocol, baud rate, and parity on the scan
assembly main board, you can install the scan assembly in the housing. The
installation procedure is the same for all housing styles (in-ceiling, pendant, or
rugged).
CAUTION
Do not remove the camera from the scan assembly.
Handle the camera lens with extreme care.
To install the scan assembly in the housing:
1. Remove the plastic lens cap and foam insert from the scan assembly.
Do not touch the lens.
2. Rotate and line up the yellow label on the scan assembly with the yellow
label on the housing.
3. Gently push the scan assembly into the housing until the two locking tabs
on the scan assembly snap into the guides on the housing.
4. Ensure that the scan assembly is attached securely inside the housing.
Figure 3-3 ACUIX Scan Assembly
After you have installed the scan assembly in the housing, and the camera lens
cap has been removed, you can install the bubble.
The installation procedure is slightly different for each type of housing.
Locking tab
Yellow label