Setting Auto Pivot; Setting The Pan And Tilt Speed - Honeywell EQUIP Series Installation And Configuration Manual

Configuring Dome Control

Setting Auto Pivot

Setting the Pan and Tilt Speed

44
Auto pivot lets you track subjects passing under the dome in a single continuous
shot. When auto pivot is enabled and the controller joystick is held in the down
position, the camera automatically turns 180 degrees when it reaches its lower
limit and continues tracking up the other side.
To enable/disable auto pivot:
1. From the OSD main menu, press 3 to select Control Options.
2. Press 2 to set auto pivot to ON or OFF (default).
You can manually set the maximum pan and tilt speed settings of the camera.
The following maximum pan speeds are available:
• 120 degrees per second
• 240 degrees per second
• 480 degrees per second
The maximum tilt speed is determined by the maximum pan speed, being half of
the maximum pan speed: 60, 120, or 240 degrees per second.
To manually set the maximum pan speed:
1. From the OSD main menu, press 3 to select Control Options.
2. Press 4 to select Set Pan and Tilt Options.
3. Press 1 to set the maximum pan speed to 120, 240, or 480 (default).
To set the dome speed as a percentage:
1. Click the Live View tab.
2. In the PTZ Speed box, type a value from 1 to 100, and then click Set.