Table 3-2 Sw5 Protocol Settings - Honeywell EQUIP Series Installation And Configuration Manual

Setting the Protocol (SW5)
Protocol Name
IntelliBus™
MAXPRO-mode
(default)
VCL - RS485
Diamond
Pelco P
Pelco D
Document 800-04194V1 Rev A
07/11
®
EQUIP Series ACUIX™ IP PTZ Dome Installation and Configuration Guide
The ACUIX IP PTZ dome supports the following protocols for communicating
with other devices:
• IntelliBus™ (recommended)
• MAXPRO-mode (default)
• VCL
• Diamond
• Pelco P
• Pelco D
The protocol is set using DIP switch SW5 on the main board (see
factory default is MAXPRO-mode (a mode of using Diamond protocol that has
special presets for functions beyond pan, tilt, zoom, focus, and preset).
Select a protocol that is compatible with the device that you want to connect to.
IntelliBus™ protocol is recommended for most installations.
Table 3-2 SW5 Protocol Settings
1 2
OFF OFF
OFF ON
ON ON
ON OFF
ON OFF
OFF ON
To set the protocol:
1. Remove the scan assembly from the pink antistatic bag.
2. Using Table 3-2 as a reference, position the pins on switch SW5 to
correspond to the protocol that you have selected.
Note Normally, pin 8 should be set to the ON position. Setting the switch to
OFF allows the address, protocol, baud rate, and parity settings to be
changed from the OSD, which is not recommended for most
installations.
Switch Position
3 4 5
OFF OFF OFF
OFF OFF OFF
OFF OFF OFF
OFF OFF OFF
ON OFF OFF
ON OFF OFF
Table 3-2). The
6 7 8
OFF OFF ON
OFF OFF ON
OFF OFF ON
OFF OFF ON
OFF OFF ON
OFF OFF ON
17