The Manual Program - Stairmaster StepMill SM916 Assembly Manual

The Manual Program

The Manual Program allows you to control the step rate of the St
during the workout, while accurately calculating exercise statistics based
on your weight. The default step rate is 41 unless changed during the data
entry mode. The workout profile in the display window is divided into 30 equal
intervals within the selected workout time. The profile is based on the MET
level, with every 1 MET equating to one vertical bar. MET level is based on a
combination of step rate and time.
1. Press the [MANUAL] key. The message, MANUAL WORKOUT will be
displayed in the text line and the workout profile displayed in the lower
display. Press [ENTER] to accept.
2. The console will display ENTER WEIGHT - LBS (or ENTER WEIGHT - KG if
in Metric mode). Enter your weight using the numeric keypad and press
[ENTER]. Or, press [ENTER] to accept the default value.
3. The console will display STEP RATE. Enter the desired step rate using the
numeric keypad (24 - 162) and press [ENTER]. Or, press [ENTER] to accept
the default value.
4. Next, the console will display ENTER TIME 5 – 99. Enter the desired time
and press [ENTER]. Or, press [ENTER] to select the default time.
If you press [0], then the timer will count-up from 0:00 to the maximum time
of 99:00.
5. The console will display ENJOY WORKOUT and the timer will begin.
The step rate may be changed at any time during the workout by pressing
the [Level: UP] key to increase the step rate, or the [Level: DOWN] key to
decrease the step rate. Any changes to the step rate will be displayed in the
current flashing column. The new step rate will continue through the rest of
the workout until changed using the Level keys.
6. Press [STOP] to pause the workout. Press [Stop] again to end the workout.
The workout statistics will be displayed, and then the console will revert
back to the SELECT WORKOUT message.
Operation
13
Owner's Manual
epM ill
SM916
®