Stairmaster StepMill SM916 Assembly Manual page 15

Figure 10
Assembly
Step 10: Connecting Power Supply
Parts
10-1 Connect the DC Power Cable from the Power Supply
to the power connector located on the bottom cover
(Figure 10).
10-2 Place the Power Supply on the floor near an AC wall
outlet.
10-3 Check that the Input AC Power Rating marked on
the Power Supply matches the available power.
To reduce the risk of electrical shock, fire and
to prevent severe damage to the machine, use
only the power supply approved for use with this
equipment. In addition, your machine must be
properly grounded.
Step 11: Final Check
Failure to visually check and test assembly before
use can cause damage to the equipment. It can
also cause serious injury to users and bystanders.
11-1 Tighten all hardware.
11-2 Refer to the Owner's Manual for Operating and
Maintenance Information.
15
Assembly Manual