Installing the lower bezel
This procedure applies only to the 5U server model with hot-swap power supplies
(Model name: 2582-F4x).
To install the lower bezel on the 5U server model with hot-swap power supplies
(Model name: 2582-F4x), complete the following steps.
1. Insert the two bottom tabs on the lower bezel into the corresponding holes in
2. Rotate the top of the lower bezel up to the chassis; then, press the blue-colored
3. Reconnect the external cables and power cords; then, turn on the attached
the front of the chassis.
release tab on the right side of the lower bezel and completely close the lower
bezel until it locks securely into place.
devices and turn on the server.
Chapter 5. Removing and replacing server components
173